HOW DO I CHANGE A TIRE?

Sooner or later, it happens to the best of us, we get a flat tire. Most of us have a roadside assistance membership of some kind but it is always good to know how to do this on your own.

FOLLOW THESE SIMPLE STEPS TO FIX THE PROBLEM AND BE ON YOUR WAY IN NO TIME...

SAFETY FIRST:

  • Find a spot to pull over. If you're on the highway, getting off is the safest bet, even if you have to drive on a blown tire. Otherwise, pull as far onto the shoulder as possible.
  • Don't park in the middle of a curve, where approaching vehicles can't see you.
  • Choose a flat spot, as jacking up your vehicle on a hill can be a disaster waiting to happen.
  • If you have a manual transmission, leave your car in gear.
  • Be sure to set your parking brake.
  • Turn on your hazard lights.
  • Get the Jack, Wrench, and Spare Tire from the vehicle (normally in the trunk), and bring them over to the tire that is flat. Use other tools or supplies if necessary.
  •  

LOOSENING THE LUG NUTS:

  • Use the Wrench to loosen the lug nuts.
  • You may need to remove the hubcap. Don't remove the lug nuts at ths point, simply loosen them by turning the Wrench to the left (counter-clockwise).
  • If the lug nuts are really tight, try placing the wrench on the nut and standing on the wrench arm to use your full weight on it.
  • You can also try hitting the wrench arm with a rock.
  •  

JACK UP THE CAR AND REMOVE THE LUG NUTS:

  • Use the Jack to lift the vehicle off the ground.
  • Different models may have different places to put the Jack; consult your owner's manual for specific locations.
  • Once the Jack is securely in the correct spot, jack up the vehicle until the tire is about six inches off the ground.
  • Remove the lug nuts and pull the tire off of the vehicle.
  • Make sure to place the lug nuts in a place where they won't get scattered, and pull the tire straight toward yourself to remove it from the wheel base.
  •  

ATTACH THE SPARE TIRE:

  • Place the Spare Tire on the vehicle.
  • Line up the lug nut posts with the holes in the Spare Tire, and push the Spare Tire all the way onto the wheelbase until it can't go any further.
  • Put on the lug nuts.
  • Don't put them on tightly, just make sure they're on enough for the Spare Tire to stay on the vehicle for a moment.
  • Lower the vehicle back to the ground.
  • Use the Jack to bring the vehicle back down to ground level.
  • Remove the Jack from underneath the car.
  •  

ON THE GROUND:

  • With the vehicle back on the ground, you can now tighten the lug nuts. MAKE SURE THE LUG NUTS ARE TIGHTENED.
  • Rather than tightening the lug nuts one at a time, start with one lug nut and tighten it about 50%, then move to the opposite nut (across the circle) and tighten this one about 50% as well.
  • Keep tightening opposite lug nuts gradually in turn until each lug nut is as tight as it can be.
  •  

CLEAN UP:

  • Put your flat tire and tools back in your trunk, or where you got them from.
  • Make sure you don't leave anything on the side of the road.

If you are lucky, a tire isn't completely destroyed when it goes flat. If the flat tire is caused by a nail or other sharp object, and you can't or don't want to change your tire, you may be able to give yourself a few miles of leeway by using a flat-fix type spray. Simply follow the manufacturer's directions. In ideal situations, the spray foam will allow you to at least find a close off ramp and pull into a Service Station or a Rest Stop before you have to change your tire.

If your tires appear worn or you have had a flat tire and need it fixed or replaced, contact our Service Department for a fast and cost efficient solution.